Transition Networks Switch SISTP10XX-141-LR(T) Manual de usuario descargar pdf (Pagina 26)

Transition Networks SISTP10xx-141-LR(T) Industrial PoE Switch

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600

Connecting copper cables

Copper cable

installation

To connect the copper cable to the Industrial PoE Switch and other equipment, do the

following:

Step Action

1. Locate or build 10Base-T or 100Base-TX compliant copper cables with male, RJ-

45 connectors installed at both ends.

2. Connect the RJ-45 connector at one end of the cable to the RJ-45 port on

the Industrial PoE Switch. See Figure 15 below.

3. Connect the RJ-45 connector at the other end of the cable to the RJ-45

port on the other device (switch, workstation, PLC, etc.).

4. Check the copper port LED on the Industrial PoE Switch to verify the

connection—LNK/ACT LED should be lit.

Figure 15: Copper Cable Installation

Copper cable

configuration

Either a straight-through or cross-over cable may be used. See Figure 16.

Figure 16: Straight-Through and Crossover Cables

Note: The AutoCross

feature determines the characteristics of the cable connection and

automatically configures the unit to link up, regardless of the cable configuration,

allowing either straight-through (MDI) or crossover (MDI-X) cables to be used.

(Requires no operator intervention.). See Advanced Features section for more

information.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

Sin comentarios

Transition Networks Switch SISTP10XX-141-LR(T) Manual de usuario Pagina 26