2.4 Installing Multichannel Media Converter at Site
The Multichannel Media Converter can be installed in a standard rack or
on a table, shelf, or other stable surface.
2.4.1 Standard Rack Installation
NOTE: Installation bracket mounting screws are provided. Rackmount
screws and clip nuts are NOT provided.
To install the Multichannel Media Converter in a standard rack:
1. Locate six (6) installation bracket screws (
provided) for each
Multichannel Media Converter chassis to be installed.
WARNING: Mount Multichannel Media Converter chassis
evenly and securely in rack. Failure to observe this warning
could allow the Multichannel Media Converter to fall, resulting
in equipment damage and/or possible injury to personnel.
2. Align universal mounting bracket in selected position against side
of Multichannel Media Converter chassis so that chassis
installation holes are visible through universal bracket installation
holes.
3. Using Phillips screwdriver, install three (3) screws through
mounting bracket into chassis installation holes on side of
Multichannel Media Converter.
4. Repeat steps 3 and 4 for second mounting bracket.
5. Locate four (4) screws (not
provided) and optional clip-nuts (not
provided) for each Multichannel Media Converter to be installed.
6. Carefully align Multichannel Media Converter at secure and level
position between the site rack mounting rails.
7. Install two (2) screws through right bracket into right mounting
rail and two (2) screws through left bracket into left mounting rail,
using clip nuts to secure if necessary.
2.6
Comentarios a estos manuales